Murano 1 (2002-2007, petrol)

Hazard warning light switch — removal and installation (Nissan Murano Z50)

0

Remove the instrument panel (3).
Disconnect the hazard warning switch plug.

Disconnect the hazard warning switch plug.

Press the latches (2) back and remove the hazard warning light switch (1).
Installation is carried out in the reverse order of removal.

[The article was obtained from the portal: NISSANBOOK.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Makar Filatov

Send this information to your friends:

◀ Previous

Murano 1: Equipment and devices

Next ▶

Classification of electrical equipment faults — the simplest testing methods
Basic concepts of electricity

Headlight and turn signal control switch — removal and installation
Intelligent Electrical Distribution Module in the Engine Compartment (IPDM ER)
Wiring harnesses
BCM (Body Control Module) — main components and controlled signals
Rear window defroster

Similar information for other Nissan models

➜ Hazard warning light switch Nissan Qashqai 1 (2006-2013)
➜ Hazard warning switch Nissan Almera 1 (1995-2000)
➜ Hazard warning switch — removal and installation Nissan Terrano 1 (1986-1995, petrol)
➜ Removal and installation the hazard warning switch Nissan Patrol 4 (1987-1997, petrol)
➜ Hazard warning switch Nissan Serena 2 (1999-2005)
➜ Hazard warning switch Nissan Bluebird T12 (1986-1991)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.