1. Disconnect the negative cable from the battery.
2. Remove the central part of the instrument panel.
3. Press one of the fastening latches, push the switch forward and remove it from the center panel.
Installation is carried out in reverse order.
Removal and installation the hazard warning switch (Nissan Patrol Y60)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Konstantin Kazakov
Similar information for other Nissan models
➜ Hazard warning switch Nissan Almera 1 (1995-2000)
➜ Hazard warning light switch — removal and installation Nissan Murano 1 (2002-2007, petrol)
➜ Hazard warning switch — removal and installation Nissan Terrano 1 (1986-1995, petrol)
➜ Hazard warning light switch Nissan Qashqai 1 (2006-2013)
➜ Hazard warning switch Nissan Serena 2 (1999-2005)
➜ Hazard warning switch Nissan Bluebird T12 (1986-1991)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to the guide
- Troubleshooting
- Maintenance
- Power unit
- Engine repair 4.2 l
- Engine repair 3.0 l
- Cooling and heating
- Power and exhaust system
- Decreased toxicity
- Engine electrical equipment
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Cardan and transfer box
- Clutch
- Chassis
- Brake system
- Front axle and suspension
- Rear axle and suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Front doors and windows
- Rear doors and windows
- Electrical equipment
- Equipment and devices
- Breakers and switches
- Lighting and signaling
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.