Removal
1. Remove the wheels from the vehicle.
2. Support the suspension arm with a suitable jack and remove the load from the spring.
3. Remove the automatic headlight leveling control unit (on models with xenon headlights). See chapter "Driver controlled instruments".
4. Remove the stabilizer connecting rod.
5. Remove the control rod from the suspension arm.
6. Remove the control rod from the suspension beam.
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
- Perform final tightening of all bolts and nuts in the installation position of the rear suspension beam and axle housing (rubber-metal bushing) in an unloaded state, when the vehicle is standing with its wheels on the ground.
Check after removal
Check the control rod and bushing for deformation, cracks or damage. Replace if necessary.
The source is indicated on the page www.NISSANBOOK.ru
Post-installation check
1. Check the rear wheel alignment angles. See above.
2. Perform the neutral position adjustment of the steering angle sensor. See chapter "Brake system".