Table of contents: Removal and installation ↓ Check after removal ↓
Air purifier and air duct 1. Air cleaner filter element; 2. Air cleaner cover; 3. Holder; 4. Air mass flow sensor; 5. Air cleaner housing; 6. Clamp; 7. Air duct and resonator assembly; 8. Rubber bushing; 9. Bushing; 10. Bracket; 11. Rubber bushing; 12. Bracket; 13. Air duct (inlet); 14. Air duct; 15. Resonator; A. To the electric throttle actuator.
Removal and installation
Removal
1. Remove the air duct (inlet).
2. Remove the battery.
3. Disconnect the electrical wiring connectors (A) and remove the bracket (1).
4. Disconnect the connector from the air mass sensor.
5. Disconnect the PCV hose.
6. Remove the air cleaner housing and air mass flow sensor assembly and the air duct and resonator duct assembly by separating them at the joint.
Source is available on the resource www.nissanbook.ru
- If necessary, apply marks to facilitate subsequent installation.
7. If necessary, remove the air mass flow sensor from the air cleaner housing.
Attention:
- Handle the mass air flow sensor with care.
- Do not hit the air mass sensor.
- Do not disassemble the air mass sensor.
- Do not touch the sensitive element of the sensor.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
- Align the marks. Connect the joints. Tighten tightly.
Check after removal
- Check for cracks or wear on the air duct and resonator assembly.
- If any deviation from the norm is detected, replace the air duct and resonator assembly.