Table of contents: Removal and installation ↓ Checking and adjusting ↓ Checking the operation of the…↓ Checking the fit ↓
Front door glass 1. Door glass; 2. Glass guide channel; 3. Assembled module; 4. Window lifter assembly; 5. Window lift motor; 6. Front door guide.
Removal and installation
Removal
1. Remove the front door trim. See the section above "Interior equipment".
2. Using the puller (A), remove both seals (1) as shown in the figure.
3. Lower or raise the door glass using the main window switch until the glass mounting bolts are visible.
4. Unscrew the glass mounting bolts.
5. Grasp the door glass and remove it from the guide.
Note: Do not raise the glass to its highest position after removing it from the door.
6. Remove the glass guide channel.
7. Remove the front door guide.
Installation
Installation is carried out in the reverse order of removal.
Checking and adjusting
Resetting the system to its original state
If the work described below is carried out, reset the system to its original state:
- power outage not the switch or window motor due to a blown fuse or disconnected from the battery etc;
- removing and installing the window lift assembly;
- removing and installing the window lift motor assembly;
- removing and installing the window lift switch connector;
- replacement of window lifters included;
- removal and installation of door glass;
- removing and installing the glass guide channel.
Procedure for resetting to initial state
After installing all components on the vehicle, perform the following operations:
1. Temporarily disconnect the cable from the negative battery terminal or disconnect the connector from the window switch for at least 1 minute, then reconnect.
2. Turn the ignition key to the "ON" position.
3. Lower or raise the door glass approximately halfway.
4. Pull the button all the way "up" (automatic closing position) and hold until the door glass rises to the upper position and for another 2 seconds then release.
5. Check that the anti-pinch function is working.
Note: The reset procedure may be cancelled if the window is continuously lowered and raised. In this case, repeat the procedure.
Checking the operation of the anti-pinch function.
1. Lower the door glass completely.
2. Place a wooden block (wooden handle of a hammer, etc.) in an almost raised position.
3. Raise the glass fully in automatic mode.
- Check that the glass changes direction without pinching the wooden block, drops approximately 150 mm or for 2 seconds and then stops.
- The glass should not rise when the main window switch is pressed during direction changing or lowering.
Attention:
- Do not test by pinching any part of the body, hand, etc. Try to avoid pinching.
- Make sure that the automatic lifting function works normally before testing after resetting the system.
Checking the fit
- Make sure the glass fits snugly into the guide groove.
- Lower the glass slightly (approximately 10-20 mm) and make sure that the glass edge is parallel to the guide. If not, loosen the window regulator, guide, glass and carrier mounting bolts and adjust the glass position.