Table of contents: Removal and installation ↓ Checking and adjusting ↓
Rear side door glass. 1. Door glass; 2. Glass guide channel; 3. Window lifter assembly; 4. Window lift motor; 5. Rear door guide (lower); 6. Rear door guide (upper); 7. Corner cover.
Removal and installation
Removal
1. Remove the rear side door trim. See section above "Interior equipment".
2. Disconnect the connector from the speaker in the rear side door.
3. Remove the sealing mesh using a knife.
(The source of the article is on the website: «NISSANBOOK.RU»)
Note: If reusing the sealing mesh, cut the butyl tape so that it remains on the sealing mesh.
4. Partially remove the glass guide channel.
5. Slightly lift the door glass, unscrew the mounting bolts of the lower guide partition and remove it.
6. Loosen the corner cover mounting screws and bolts and remove the corner cover assembly.
7. Lower or raise the door glass using the window switch until the glass mounting bolts are visible.
8. Unscrew the glass mounting bolts.
9. Remove the door glass from the inside or outside of the door panel.
10. Remove the glass guide channel.
Installation
Installation is performed in the reverse order of removal.
Checking and adjusting
Checking the fit
Make sure the glass fits snugly into the guide groove.
Lower the glass slightly (approximately 10-20 mm) and make sure that the glass edge is parallel to the guide. If not, loosen the window regulator, glass guide and carrier mounting bolts and adjust the glass position.