Hood grille. 1. Windshield wiper arm and blade (right); 2. Windshield wiper lever cover (right); 3. Windshield wiper arm and blade (left); 4. Windshield wiper arm cover (left); 5. Front fender cover (left); 6. Windshield wiper drive assembly; 7. Hood grill extension; 8. Lower insulator of the upper part of the partition; 9. Hood grille seal; 10. Bonnet grille cover plug; 11. Hood grille cover; 12. Front fender cover (right); 13. Washer nozzle; 14. Double-sided adhesive tape; 15. EPT seal.
Removal and installation
Removal
1. Open the hood completely.
2. Remove the windshield wiper arm (left/right) from the car.
3. Remove the cover from the front fender (left/right).
4. Disconnect the windshield washer tube connector.
5. Remove the retaining clips from the hood grille cover, then pull it forward and separate it from the windshield.
6. After removing the hood grille cover, remove the following components:
- bonnet grille seal;
- hood grille cover plug;
- washer jet;
- washer tube;
- EPT seal.
7. Remove the windshield wiper drive assembly.
[The original is posted on the portal NISSANBOOK]
8. Loosen the hood grille extension mounting bolts, then remove the extension.
9. Unscrew the fastening nuts of the lower insulator of the upper part of the partition and remove it.
Installation
Installation is carried out in the reverse order of removal.
Attention:
- When installing the hood grille cover, check that the blind clips are positioned correctly over the holes in the body panel, then press them in.
- When installing an old hood grille, always replace the EPT seal at the rear of the hood grille cover with a new one.
- After installation, adjust the wiper arms.