Table of contents: Removal ↓ Installation ↓
1. Front fender cover; 2. Rubber seal and foam; 3. Windshield washer hose; 4. Plastic retainer*; 5. Hood grille; 6. Rubber seal of the hood grille; 7. Cover with the VIN number of the car; 8. Hood grille seal; 9. Windshield wiper motor and linkage; 10. Hood grill extension; 11. Partition insulator; 12. Plastic nuts.
* See text
Removal
1. Remove the windshield wiper motor and rods (left and right). See chapter Electrical equipment.
Information copied from the portal (www.NISSANBOOK.ru)
2. Disconnect the hose from the windshield washers.
 |
 |
3. Remove the front fender cover (left and right).
4. Remove the plastic retainer as follows:
Move the center clamp up and down and hold it.
Pull the plastic clip towards the front of the vehicle to disengage the clip.
5. Remove the plastic clips from the hood grille on the left and right sides.
6. Remove the rubber seal (left and right) and polystyrene foam.
7. Disconnect the windshield wiper wiring from the hood grille extension.
8. Remove the plastic nuts and mounting screws from the hood grille extension and remove it.
Installation
Installation is performed in the reverse order of removal.
Caution: When installing an old bonnet grille, always replace the seal with a new one.