The vertical beam is adjusted using the adjusting screw (arrow in the figure NM.22.050).
The vertical beam is adjusted using the adjusting screw (arrow in the figure NM.22.050).
Front fog lights — adjustment (Nissan Murano Z50)
All conditions required for adjustment are the same as those described above for headlights, with two exceptions. First, the distance L should not be 10 m, but 7.5 m, and second, the line (2) should be drawn below the line (1) not by 55 mm, but by 130 mm (dimension C).
The vertical beam is adjusted using the adjusting screw (arrow in the figure NM.22.050).
The vertical beam is adjusted using the adjusting screw (arrow in the figure NM.22.050).
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Makar Filatov
Similar information for other Nissan models
➜ Adjustment of front and rear seats Nissan Terrano 1 (1986-1995, petrol)
➜ Adjustment of the geometry of the front suspension and… Nissan Patrol 4 (1987-1997, petrol)
➜ Front door locks — checking and adjustment Nissan Serena 2 (1999-2005)
➜ Front doors — removal, installation and adjustment Nissan Sunny 7 (1990-1998)
➜ Front combination lights Nissan X-Trail 2 (2007-2013, petrol)
➜ Fog lights — headlight beam adjustment Nissan Note 1 (2004-2013)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to manual
- Maintenance
- Power unit
- Gasoline engines
- Engine overhaul
- Lubrication system
- Cooling system
- Fuel system
- Engine management
- Exhaust system
- Transmission
- Variator (CVT)
- Transfer case
- Drive shafts
- Rear axle
- Chassis
- Front suspension
- Rear suspension
- Steering system
- Wheels and tires
- Brake system
- Body
- Body elements
- Electrical equipment
- Power devices
- Lighting and signaling
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.