Table of contents: Window glass ↓ Regulator ↓
Window glass
1. Open the door and remove the interior trim panel (see Chapter 33 of this Section).
2. Remove and disconnect the speaker.
3. Disconnect and remove (where it is equipped) window amplifier with glass servo drive and armrest suspension (see photo).
28.3. Armrest suspension and window amplifier with glass servo drive
(Text duplicated from the website: «www.nissanbook.ru»)
4. Remove the polyethylene seal.
5. Lower the window lift (on manually operated windows) or connect the window switch to the window servo(window with glass servo drive), then lower the window until the mounting bolts appear in the door opening (see photo).
28.5. Door window glass mounting bolts (marked with arrows)
6. On the front doors, loosen the single bolt securing the bottom edge of the dash panel (see photo).
28.6. Front door window glass panel mounting bolt (shown by arrow)
7. On the rear doors, loosen the two bolts securing the lower edge of the rear panel (see photo).
28.7. Rear Door Window Glass Panel Rear Mounting Bolts (marked with arrows)
8. Unscrew the window glass regulator bolt and pull out the glass, tilting it so that it is removed from the door opening (see photo).
28.8. Removing the front door window glass
9. After the rear door window glass has been removed, the triangular vent can be removed by unscrewing the bolt from the rear panel and removing the glass. The panel is secured with two bolts at the bottom edge and one screw at the top, remove the seal through the door opening to gain access to the screw (see photo).
28.9. Upper mounting screw for rear door rear panel
10. Assembly is carried out in the reverse order. Lubricate the mechanism and adjust it.
Regulator
11. Remove the window glass as described above.
12. Remove the top of the regulator channel and the bottom mounting bolt (see photo).
28.12A. Upper mounting bolts of the front door regulator channel (marked with arrows)
28.12B. Upper mounting bolts of the rear door regulator channel (marked with arrows)
28.12C. Bolts for lower mounting of the regulator channel (marked with arrows)
13. On windows with a manual regulator, remove the regulator mechanism mounting bolts (see photo).
28.13. Manual window lift mechanism mounting bolts (marked with arrows)
14. On power windows, disconnect the wiring and remove the motor mounting bolts (see photo).
28.14A. Disconnecting the engine wiring, power window glass
28.14B. Engine mounting bolts, front door windows with power glass (marked with arrows)
28.14C. Engine mounting bolts, power rear door windows (marked with arrows)
15. Remove the regulator assembly (see photo) from the door.
28.15. Door window regulator assembly - window with glass servo drive
16. Assembly is performed in the reverse order. Lubricate the regulator and check the normal operation of the window lifter. Tighten all bolts securely.