Table of contents: Removal and installation ↓ Post-installation check ↓
Accelerator pedal assembly.
Removal and installation
Removal
1. Loosen the mounting nuts and remove the accelerator pedal assembly.
Attention:
- Do not disassemble the accelerator pedal. Do not remove the accelerator pedal position sensor from the accelerator.
- When carrying out work, avoid impacts resulting from falls, etc.
- Do not allow water to come into contact with the pedal.
2. Disconnect the connector from the accelerator pedal position sensor.
[Source is available on the resource: www.NISSANBOOK.ru]
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
- Insert the dowel pin from the vehicle side and secure the accelerator pedal assembly.
- Tighten the accelerator pedal assembly mounting nuts.
Post-installation check
Make sure the accelerator pedal moves smoothly throughout its entire travel when fully depressed and released.
Make sure the accelerator pedal returns securely to the fully released position.
For operations to check the electrical part of the accelerator pedal position sensor, see chapter "Engine management system".