Table of contents: Transmission oil ↓ 4WD models ↓
Transmission oil
2WD models
Drain
1. Start the engine and warm up the gearbox.
2. Turn off the engine. Remove the drain plug and drain the transmission oil.
3. Place a new gasket on the drain plug and screw it into the clutch housing. Tighten to the specified torque.
Caution: Do not reuse the pad.
Refueling
1. Unscrew the plug (1). Pour fresh transmission oil into the gearbox.
Oil grade and viscosity: See chapter "Maintenance".
Oil filling capacity (standard): See below p. "Technical data and specifications".
2. After refueling, check the oil level. See below.
A. Suitable feeler gauge.
3. Place a new O-ring on the drain plug and screw it into the clutch housing.
Caution: Do not reuse the O-ring.
4. Tighten the plug mounting bolt to the specified torque.
Checking for leaks
Make sure there are no oil leaks from the manual transmission and adjacent areas.
Checking the level
1. Unscrew the plug (1).
2. Measure the oil level using a suitable dipstick (A) as shown in the figure and make sure it is within the normal range.
Oil level "L": See below. "Technical data and specifications".
Attention:
- Do not start the engine while checking the oil level.
- Measure the oil level using a suitable dipstick through the hole under the filler plug.
3. Place a new O-ring on the filler plug and screw it into the transmission housing.
Caution: Do not reuse the O-ring.
4. Tighten the plug mounting bolt to the specified torque.
4WD models
Drain
1. Start the engine and warm up the gearbox.
2. Turn off the engine. Remove the drain plug and drain the transmission oil.
3. Place a new gasket in the drain plug and screw it into the clutch housing. Tighten to the specified torque.
Caution: Do not reuse the pad.
Refueling
1. Unscrew the plug (1) from the filler hole. Pour fresh transmission oil into the gearbox.
A. Suitable feeler gauge;
In front of the car.Oil grade and viscosity: See chapter "Maintenance".
Oil filling capacity (standard): See below p. "Technical data and specifications".
2. After refueling, check the oil level. See below.
3. Place a new gasket on the filler plug and screw it into the gearbox housing.
Caution: Do not reuse the pad.
4. Tighten the filler plug to the specified torque.
Checking for leaks
Make sure there are no oil leaks from the manual transmission and adjacent areas.
Checking the level
1. Unscrew the plug (1) from the filler hole.
2. Measure the oil level using a suitable dipstick (A) as shown in the figure and make sure it is within the normal range.
Front of the carOil level "L": See below. "Technical data and specifications".
Caution: Do not start the engine while checking the oil level.
Measure the oil level using a suitable dipstick through the hole under the filler plug.
3. Place a new gasket on the filler plug and screw it into the gearbox housing.
Caution: Do not reuse the pad.
4. Tighten the filler plug to the specified torque.