Note. The procedure for removing and installing the grille is the same for all vehicle models. The procedures for the Hardtop and Estate models are described below.
Removing
1. Raise the hood and secure it with the stop.
2. Give screws of fastening of the combined lanterns to the front panel of the car. Remove the lights, after disconnecting the wiring from them.
3. Using a screwdriver, turn the latches a quarter of a turn (shown by arrows in accompanying illustrations (Utilities (Van) and mini truck) And (Hardtop and Wagon)).
4. Slightly tilt the grille forward, then pull it up to remove it.
Note. On some vehicles it may be necessary to first remove the frame of the cattle breaker (depending on its design).
Installation
Installation is in the reverse order.
1. To remove the clips from the front panel, squeeze them and turn a quarter of a turn.
2. Insert the tabs into the square holes in the grille, then turn them.
3. Place the grille on the lower anchor points and push it back to snap the latches into the parent panel.
4. On Hardtop and Wagon models, install the combination lamps by firmly tightening their fastening screws.