Table of contents: Removal ↓ Installation ↓
Removal
When removing and installing, follow these instructions: illustration above. On models with a carburetor engine, only one fan is installed, which is secured in the same way.
1. Drain the coolant as described in Chapter Routine care and maintenance.
2. Disconnect the upper and lower radiator hoses from the radiator and engine after loosening the hose clamps.
3. On a vehicle with an automatic transmission, disconnect the oil cooler inlet and outlet hoses. Place a container underneath to catch any leaking oil.
4. Disconnect the battery.
5. Disconnect the electrical cables at the fan motor or motors and the thermal switch.
6. Loosen the mounting nuts on the top side, remove the corners and take out the radiator, making sure that the radiator honeycomb does not hit any engine or body parts. The rubber mounts on the bottom of the fan shroud can be replaced if they are in poor condition.
7. If necessary, remove the installed casing or individual shields from the radiator.
Installation
Installation is carried out in the reverse order. If you suspect a fault in the water hoses, they should be replaced. Do not forget to connect the plugs of the fan motors and the thermal switch. Fill the coolant as described in Chapter Routine care and maintenance. After the engine has warmed up, check all connections for leaks. Also check that the fan motors turn on and off.
The publication is reprinted from this resource www.nissanbook.ru