Front wing — removal and installation (Nissan Bluebird T12)

1. Remove the front bumper (see Chapter 12 of this Section).

2. Remove the front spoiler or front panel as equipped (see Chapter 11 of this Section).

3. Remove the mounting screws and remove the wing.

4. Raise the front of the car and remove the wheel.

5. Pull out the mounting brackets and remove the screws, then remove the mudguard and protective strip from the rear wheel arch projection and remove the wheel arch liner from the inner part of the fender.

6. Remove the shield from under the wing, if necessary (four bolts and two plastic brackets) and the air intake pipe (only on fuel injected models). which is secured with screws and four brackets (at the top end). Remove the turn signals (see Section 12).

7. Remove a number of wing mounting bolts: from the top edge, front and rear of the wing.

8. Make a cut along the seam and remove the wing.

9. Before installing a new wing, clean the protrusions on the body and apply fresh mastic.

10. Install the wing and tighten the screws and bolts.

11. Apply protective coating under the fender and paint the outer surface to match the body color.

12. Assembly is carried out in reverse order.