Engines MR20DE and QR25DE 1. Gearbox assembly; 2. Concentric slave cylinder (CSC).
Removal and installation
Attention:
- When removing a manual transmission from a vehicle, always replace the concentric slave cylinder (CSC). To remove the manual transmission, the CSC insert is returned to its original position. Dust on the sliding components of the clutch driven plate can damage the CSC seal and cause clutch fluid leakage.
- Do not disassemble the CSC cylinder.
- Do not spill adhesive fluid on painted surfaces or other components. If any fluid is spilled, wipe it up immediately and rinse the area with water.
Removal
1. Remove the manual transmission assembly from the vehicle. See below.
The material is based on data from the portal (Nissanbook.ru)
2. Loosen the mounting bolts and remove the concentric slave cylinder (CSC) from the clutch housing.
Installation
1. Install the CSC cylinder to the clutch housing and tighten the bolts to the specified torque.
Attention:
- Do not reuse the CSC cylinder.
- Do not insert or operate the CSC cylinder, as the piston and CSC component stopper may fall out.
2. Install the manual transmission assembly on the vehicle. See below.
3. Bleed the air from the clutch hydraulic system. See above.