Table of contents: Removal ↓ Installation ↓
Warning! The air conditioning system is under constant high pressure. Never disconnect refrigeration lines or remove any system components without first discharging the system. Discharging the air conditioning system must be done by an experienced technician in a car service workshop. Always wear safety glasses when disconnecting refrigeration lines!
When replacing air conditioning system components, a certain amount of replacement refrigeration oil will be required to fill the volume of the new unit. Use only oil suitable for use in R-134a systems (read the container label carefully).
Removal
1. Discharge the air conditioning system in a specialized workshop.
2. Disconnect the negative cable from the battery.
Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination to activate the audio system before disconnecting the battery! Drain the cooling system (see Chapter Settings and ongoing maintenance).
3. Disconnect the two refrigeration lines from the condenser. Immediately plug the open ends of the lines and fittings to prevent dirt and moisture from entering the system.
4. Remove the radiator (see section Removal and installation the radiator and expansion tank of the cooling system).
5. Remove the condenser mounting bolts.
6. Tilt the capacitor assembly back and remove it from the motor.
Installation
1. Installation is carried out in the reverse order. When installing a new condenser, pour 30÷50 ml of fresh refrigerant into it.
2. Recharge the system in a specialized workshop.