Murano 1 (2002-2007, petrol)

Capacitor — removal (Nissan Murano Z50)

0

Disconnect the condenser harness connector.
Check the conductivity of the capacitor between its contacts. Required resistance value: 1 MOhm or higher.

The location of the capacitor is indicated by an arrow in the figure.

The location of the capacitor is indicated by an arrow in the figure.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Makar Filatov

Send this information to your friends:

◀ Previous

Murano 1: Engine management

Next ▶

Ignition coil
Coolant temperature sensor
Mass air flow sensor (air flow meter)
Camshaft position sensor
Electronic control unit (ECM)

Knock sensor
Crankshaft position sensor (POS)
Oxygen sensor (lamda probe)
Inlet air temperature sensor
Power steering oil pressure switch

Similar information for other Nissan models

➜ Removal and installation of the K/V capacitor — removal and… Nissan Maxima 4 (1994-1999)
➜ Capacitor — removal and installation Nissan Terrano 1 (1986-1995, petrol)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.