Rear suspension crossmember — removal and installation (Nissan Bluebird T12)

1. Apply the handbrake, engage 1st or reverse gear (manual transmission) or "R" (automatic transmission). Block the front wheels, lift the rear of the car. Remove both wheels.

2. Unscrew all four lock nuts and bolts of the balancer joints. Remove, if necessary, the rear (adjustable) balancers.

3. Loosen the bolts securing the ends of the rear anti-roll bar to the suspension at the bottom of the suspension struts, remove the anti-roll bar clamps.

4. Unscrew the four mounting nuts, remove the crossbar with the cross balancers. Remove the balancers.

5. Installation is carried out in the reverse order. Tighten the crossmember mounting nuts to the tightening torque specified in Specifications.

6. Lower the vehicle and shake it to settle the suspension components. Tighten to the specified torque Specifications, lock nuts of the cross-balancer pivot bolt, clamp bolts of the anti-roll bar.

7. Adjust the toe-in and check the wheel turning angles.

Source is available on the resource: NissanBook