On-car service — checking the neutral position of the steering wheel (Nissan X-Trail T31)

1. Make sure that the steering gear assembly, steering column and steering wheel are installed correctly.

2. Perform a neutral position check after checking the front wheel alignment angles. Refer to Chapter "Front axle and suspension".

3. Turn the steering wheel to the straight-ahead position and make sure it is in neutral.

4. If the steering wheel does not reach the neutral position, loosen the outer tie rod ends locknuts and adjust by turning the inner tie rod ends in opposite directions until the distance on the left and right becomes the same.

The source is published on the portal (NISSANBOOK.RU)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Andrey Lazarev

Send this information to your friends:

◀ Previous

X-Trail 2: Steering

Next ▶

On-car maintenance — checking the steering wheel play
On-car maintenance — checking steering wheel axial play

On-car maintenance — checking steering wheel turning moment
On-car maintenance — checking the front wheel steering angle
Car repair — steering wheel
Car repair — steering column
Car repair — steering gear and steering drive

Similar information for other Nissan models