Examination
Checking for leaks
Make sure there are no oil leaks from the manual transmission and adjacent areas.
Checking the level
1. Unscrew the plug (1) from the filler hole.
2. Measure the oil level using a suitable dipstick (A) as shown in the figure and make sure it is within the normal range.
Oil level "L": See chapter "Clutch and manual transmission".
Attention:
- Do not start the engine while checking the oil level.
- Measure the oil level using a suitable dipstick through the hole under the filler plug.
3. Place a new gasket on the filler plug and screw it into the gearbox housing.
Caution: Do not reuse the pad.
4. Tighten the filler plug to the specified torque.
Oil drain
1. Start the engine and warm up the gearbox.
2. Turn off the engine. Remove the drain plug and drain the transmission oil.
3. Place a new gasket on the drain plug and screw it into the clutch housing.
- Tighten to the specified torque.
Caution: Do not reuse the pad.
Oil filling
1. Unscrew the plug (1) from the filler hole. Pour fresh transmission oil into the gearbox.
Oil grade and viscosity: See above. Oil filling capacity (standard): See chapter "Clutch and manual transmission".
2. After refueling, check the oil level. See below.
3. Place a new gasket on the filler plug and screw it into the gearbox housing.
Caution: Do not reuse the pad.
4. Tighten the filler plug to the specified torque.