Table of contents: Removal and installation ↓ Check after removal ↓
Removal and installation
Removal
1. Remove the ignition coils. See below.
2. Remove the spark plugs using a wrench (suitable special tool).
Key with magnet to hold spark plug.
Do not drop or hit spark plugs.
Installation
Installation is performed in the reverse order of removal.
Check after removal
Under normal operating conditions, use standard spark plugs.
Spark plug (standard):
See below section "Technical data and specifications".
Attention:
- Do not drop or hit spark plugs.
- Do not clean with a wire brush.
- If there is carbon deposits on the spark plug tip, you can use spark plug cleaner.
Air pressure in the purifier: Less than 588 kPa (6 kg/cm²).
Cleaning time: Less than 20 seconds.
There is no need to check or adjust the spark gap between replacements.
