Removal
1. Remove the wheels from the vehicle.
2. Separate the outer tie rod ends from the steering knuckle. See Chapter "Steering".
3. Remove the stabilizer connecting rod.
4. Remove the engine protection from the bottom.
5. Remove the rear torque rod.
6. Separate the intermediate shaft from the steering gear. See chapter "Steering".
7. Support the front suspension beam with a suitable jack.
8. Remove the front suspension beam strut from the vehicle.
9. Gradually lower the jack with the front suspension beam and unscrew the stabilizer mounting bolts.
10. Unscrew the mounting bolts (+) of the stabilizer brackets, then remove the brackets and stabilizer bushings from the front suspension beam.
11. Remove the stabilizer bar from the vehicle.
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
Attention:
- Install the stabilizer bushings with the slot facing the front of the vehicle.
- Install the stabilizer brackets with the cutout facing the front of the vehicle.
Check after removal
Check the stabilizer link rod, bushings and brackets for deformation, cracks or damage. Replace if necessary.