Removal and installation the front anti-roll bar (Nissan Maxima A32)

1. Set the parking brake and chock the rear wheels. Loosen the front wheel nuts. Jack up the front of the car and place it on supports. Remove the wheels.

2. Disconnect the stabilizer bar links from both suspension control arms.


3. Remove the clamps of the stabilizer bar support bushings.


4. Remove the stabilizer bar assembly.



5. After removing the rod, remove the clamp assemblies from it and carefully check the condition of the rubber bushings. If signs of material destruction are detected, replace the defective components.

Data taken from this portal NissanBook.ru

6. Installation is carried out in the reverse order. Make sure that the bushings are turned with the cuts forward, and all fasteners are tightened with the required force.