Table of contents: Checking the wiper gear motor ↓ Installing the purifier ↓ Check valve for washer ↓
Checking the wiper gear motor
1. Set the headlight washer switch to the OFF position.
2. Check for conductivity between the connector contacts.
If the movement of the wiper is obstructed, the protective circuit built into the gear motor is activated, which interrupts the power supply to the electric motor. If the wiper does not work even after the obstacle is removed, turn off the ignition for about 1-3 minutes.
Installing the purifier
Install the lever with the brush on the axle so that the brush is under the lower limiter. Tighten the nut. Install the brush on the lower limiter and tighten the nut to a torque of 2.3-3.0 Nm.
Check valve for washer
The valve is installed in the washer hose slot in the location shown in the figure. When installing the valve, ensure that it is oriented correctly.
