Assembling the lock latch
1. Remove the screws securing the latch to the door. Put your hand through the access hole into the door frame and disconnect the actuator rods from the latch.
2. On models equipped with a single lock, disconnect the corresponding electrical wiring.
3. Remove the latch and, if equipped, the electromagnetic actuator of the lock.
4. Installation is carried out in reverse order.
External handle and door lock cylinder
1. Disconnect the actuator rod from the outer door handle, loosen the mounting nuts and remove the handle from the door panel.
2. Disconnect the electrical wiring from the door lock actuator. Using pliers, release the retaining clip and remove the lock cylinder from the door.
3. Installation is carried out in reverse order.
Inner handle
1. Remove the door interior trim panel (see section Removal and installation interior door trim panels).
2. Remove the mounting screws, release the inner handle assembly from the door frame and disconnect the actuator rod(s) from it. Remove the handle.
3. Installation is carried out in reverse order.