1. Disconnect the vacuum hose and connect the vacuum gauge through the three-way adapter.
2. Start the engine and measure the vacuum produced at idle speed. Nominal vacuum: - 86.6 - 101.3 kPa (from - 866 to - 1.013 mbar or from - 650 to - 760 mmHg.).
Vacuum Pump — Checking Before Installation (Nissan Qashqai J10)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Valeria Kuznetsova
Similar information for other Nissan models
➜ Water Pump — Removal, Checking and Installation Nissan Almera 1 (1995-2000)
➜ Checking the condition and replacing the water pump Nissan Maxima 4 (1994-1999)
➜ Checking the power steering pump outlet fluid pressure Nissan Murano 1 (2002-2007, petrol)
➜ Checking and repairing the fuel pump Nissan Primera 1 (1990-1996, petrol)
➜ Vacuum Pump — Removal Nissan Serena 2 (1999-2005)
➜ Checking the hose and the control vacuum booster (60,000 km) Nissan Sunny 7 (1990-1998)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Faults en route
- Daily checks
- User manual
- Maintenance
- Power unit
- Petrol engines 1.6L (HR16)
- Petrol engines 2.0L (MR20)
- Diesel engines 1.5L (K9K)
- Diesel engines 2.0L (M9R)
- Cooling system
- Engine lubrication system
- Engine power system
- Engine management system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Car gearbox
- Transfer case and shafts
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Safety system
- Heating and air conditioning
- Electrical equipment
- Wiring harnesses
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.