Final tightening of fasteners when installing rubber suspension parts must be performed on a fully loaded but unloaded vehicle standing on the ground.
After installing the removed suspension parts, check and, if necessary, adjust the wheel alignment angles.
When removing and installing brake hoses, use a spanner.
When installing the brake hoses, be sure to adhere to the specified tightening torques.
General remarks (Nissan Almera N15)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Sofia Shapovalova
Similar information for other Nissan models
➜ General information about maintenance Nissan Maxima 4 (1994-1999)
➜ General repair recommendations — precautions Nissan Murano 1 (2002-2007, petrol)
➜ Procedure for performing adjustments — general notes Nissan Terrano 1 (1986-1995, petrol)
➜ General information about 4.2L engines Nissan Patrol 4 (1987-1997, petrol)
➜ General information about the setup Nissan Primera 1 (1990-1996, petrol)
➜ Micrometers — general information and design Nissan Qashqai 1 (2006-2013)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- User manual
- Control devices
- Preparing to move
- Heating, air conditioning and audio
- Starting the engine and driving
- Maintenance
- Technical information
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Control system (gasoline)
- Control system (diesel)
- Power and exhaust system
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body
- Heating and air conditioning
- Safety system
- Body elements
- Electrical equipment
- Equipment and devices
- Power devices
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.