Shoulder strap height adjustment
(for front seats)
The upper anchorage of the shoulder belt must be adjusted to the most comfortable position for the seated person, taking into account that the belt must pass over the shoulder. To set the mount to the desired position, press the release button and slide the mount.
Shoulder strap bracket
(for 3-door hatchback models)
The shoulder belt can be adjusted to two positions in the height of the upper anchorage according to the height of the passenger.
The position is selected by turning the bracket.
The height of the belt attachment is chosen so that the belt can be pulled out without effort.
ATTENTION! Before leaving the machine, the bracket must be returned to its original position.
Hook for shoulder strap (if available)
The rear seat belts must be hooked as shown in the illustration when not in use or when the rear seat is folded down.
CAREFULLY! Before fastening the belt, make sure that it is unhooked.
Two point belt
(seat in the middle of the back seat)
Fastening the belt
1. Insert the tongue into the buckle with the inscription "CENTRE" before snapping.
2. To lengthen the strap, pull it out while holding the tab at a right angle to the strap. To shorten the strap, pull the free end of the strap away from the tongue and move the tie to remove any slack.
3. Position the waist belt close to your hips as shown.
Unfastening the belt
To unfasten the belt, press the button on the buckle.
Fasten the seat belts even when not in use to prevent the doors from pinching the belt sheet.
Be careful when choosing a pair of belts
The center seat belts have the buckle and tongue marked "CENTRE". The center seat belt tongue only fits the corresponding center seat belt buckle.