2. Remove the mudguard.
3. Unscrew the stabilizer rod nuts (photo).
3.3 Before unscrewing the tie rod nut, mark the washers and gaskets
4. Remove the rods, taking note of the bushings and washers.
5. Unscrew the bolts and remove the stabilizer (photo).
3.5 Stabilizer bracket bolts.
6. If necessary, remove the bushings from the stabilizer.
7. Check the condition of the rod bushings, replace if necessary.
8. Installation is performed in the reverse order. Install the stabilizer so that the white marks near the bushings are visible from both sides of the car. Install the stabilizer rod parts in the same order. Finally tighten the bolts after lowering the car.