Anti-roll bar mount on the underside of the car. On the left is the bar of a car with an injection engine
1 - connecting rod; 2 - nut, 42-52 Nm; 3 - mounting clamp; 4 - bolt, 40-50 Nm; 5 - anti-roll bar; 6 - rubber bushings
The anti-roll bar mount on the ball joint on the model with an injection engine can be seen in illustrations (positions 5 to 7). On the model with a carburetor engine, the rod connection is shown in illustrations. The illustration above shows another stabilizer bar mount. When removing, proceed as follows:
1. Place the front of the vehicle on supports.
2. Loosen the stabilizer connecting rod as shown in the illustration Upper wishbone mount or Fastening the anti-roll bar on a carburetor model.
3. Unscrew both stabilizer clamps on the left and right sides of the rod and remove the stabilizer from the front of the body. The illustration shows the mounting locations in the case of an installed injection engine. Immediately after removal, check the stabilizer and both mounting clamps. The stabilizer has a color designation and the mounting clamps with their edges should lie on the same line with the colored lines. The mounting clamps are open on one side. This side should face the rear of the car.
The anti-roll bar is attached to the suspension in the places indicated by arrows.
4. Installation is carried out in reverse order. Some instructions should be followed:
5. Put on the mounting clamps and rubber feet according to the instructions above and screw the clamps. Do not tighten the bolts yet.
6. When installing the connecting rod, insert the ball joint and tighten it so that the pin is at a right angle to the rod. Do not skew the joint. Tighten the joint nuts with a force of 41-51 N·m.
7. When tightening the nut (5) (see illustration) or nuts (4) on illustrations place the wrench on the Allen key, approximately in the middle of the rod, as shown in detail (A) (see illustration below), so that it doesn't turn.
When tightening the nuts, hold the stabilizer bar as shown in fragment "A".
8. Once the vehicle is back on its wheels, tighten the tie rods.