Attention.
- The final tightening of the suspension threaded connections should be done with the vehicle running on the ground. Oil reduces the life of the rubber bushings. Therefore, it is necessary to carefully wipe off any spilled oil. Running condition is the condition of the vehicle when it is fully fueled with fuel, coolant and oil and is ready to drive. The spare wheel, jack, hand tools and mats are in place.
- After servicing the suspension components, it is necessary to check the wheel alignment angles.
- Self-locking nuts are not reusable. Always tighten new ones. If a new self-locking nut is coated with grease, it should be used as is.
Precautionary measures (Nissan Qashqai J10)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Valeria Kuznetsova
Similar information for other Nissan models
➜ Dismantling the power unit — safety measures Nissan Terrano 1 (1986-1995, petrol)
➜ General information, recommendations and safety measures Nissan Micra 3 (2002-2010, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Faults en route
- Daily checks
- User manual
- Maintenance
- Power unit
- Petrol engines 1.6L (HR16)
- Petrol engines 2.0L (MR20)
- Diesel engines 1.5L (K9K)
- Diesel engines 2.0L (M9R)
- Cooling system
- Engine lubrication system
- Engine power system
- Engine management system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Car gearbox
- Transfer case and shafts
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Safety system
- Heating and air conditioning
- Electrical equipment
- Wiring harnesses
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.