Table of contents: Removal ↓ Installation ↓
Removal
1. Disconnect the exhaust gas sensor connector from the wiring side.
2. Loosen the bolts and remove the manifold casing.
3. Unscrew the fitting nut and remove the recirculation tube.
4. Apply the handbrake and raise the front of the car.
5. Unscrew the nuts and bolt and remove the exhaust pipe, remove the gasket.
6. Loosen the nuts and bolts securing the exhaust manifold to the cylinder head in the reverse order.
7. Remove the manifold and gasket.
[Information obtained from the website: nissanbook.ru]
Installation
1. Installation is carried out in reverse order.
2. Before assembly, replace all gaskets, thoroughly clean the separating surfaces, replace or repair damaged studs.
3. Tighten the bolts and nuts with a torque wrench in the specified sequence.