Rear suspension stabilizer — removal and installation (Nissan Terrano 1)

1. Raise the rear of the vehicle and support it on stands.

2. Unscrew the stabilizer rod nuts (photo).



3. Disconnect the rods from the lower rods and stabilizer.

4. Unscrew the bracket bolts and remove the stabilizer.

5. If necessary, remove the bushings from the stabilizer.

6. Check the condition of the rod bushings, replace if necessary.

7. Installation is performed in the reverse order. Install all parts in their original order. Finally tighten the stabilizer bracket bolts after lowering the car.