Removing
1. Disconnect the battery from the ground, remove the air filter.
2. Raise the vehicle and place it on stands.
3. Disconnect from a collector a forward exhaust pipe.
Removing the right manifold
4. Remove heat shields (photo).
8.4 Right exhaust manifold parts
1. Gasket; 2, 3. Thermal shields; 4. Collector
5. Loosen the manifold nuts (photo).
8.5 Exhaust manifold nut loosening sequence
1. Right manifold; 2. Left manifold; 3.4. Front end
6. Lift the rear of the manifold and remove the manifold.
Left manifold
7. Remove heat shield bolts (photo).
8.7 Parts of the left exhaust manifold
1. Recirculation tube
2. Gasket
8. Disconnect the recirculation tube.
9. Working from below, remove three nuts each from the top and bottom and disconnect the exhaust pipe (photo 8.5).
10. Get a collector from outside a motor compartment.
Installation
11. Clean the manifold of seal residues.
12. Install a new gasket on the cylinder head. Tighten bolts and nuts in sequence (photo).
8.12 Sequence for tightening exhaust manifold nuts
1. Right; 2. Left
13. Remaining operations are carried out in reverse order.