Table of contents: Removal ↓ Installation ↓
Removal
1. Decompress the fuel system.
2. Disconnect the battery from ground.
Right cover
3. Disconnect the crankcase ventilation hose (photo).
4.3 Hoses and wires that need to be disconnected to remove the right cylinder head cover
4. Mark and disconnect the wires from the spark plugs, move them to the side.
5. Disconnect the hoses and wires from the cover.
6. Loosen the cover screws and remove the washers.
7. Remove the lid by carefully opening the seal.
Left cover
8. Disconnect the breather hose from the cover (Photo).
4.8 Hoses and wires that need to be disconnected to remove the left cylinder head cover
9. Mark and disconnect the wires from the spark plugs.
10. Remove the wires from the brackets.
11. Unscrew 9 screws and remove the cover.
Installation
12. Clean the cover from the remains of the seal, apply sealant to the cover groove and lay the gasket. After the sealant has set, install the cover and tighten the screws.
13. Tighten the screws evenly in 3-4 steps.
14. The remaining procedures are performed in reverse order.
15. Warm up the engine and check for leaks.