Removing
1. Fully raise the window pane and remove the interior door handles, trim panel, and resin seal film.
2. Disconnect the actuating rod of the lock from the outer door handle, releasing it from the plastic retainer.
3. Give nuts of fastening of the handle to the external panel of a door. Remove the handle.
Installation
Installation is in the reverse order.
1. Check the condition of the outer door handle seal. Replace the seal if necessary.
2. If necessary, replace the actuator stem retainer.
3. Adjust the position of the nut of the actuating rod of the outer handle, achieving a gap between it and the lock lever of 0.5÷1.5 mm (with the handle released).
4. Before reinstalling the polymer sealing film and the door trim panel, check that the lock and power window mechanisms are functioning properly.