Qashqai 1 (2006-2013)

Removal and installation the all-wheel drive (4WD) control unit (Nissan Qashqai J10)

1. Remove the glove box cover assembly.

2. Disconnect the wiring connector of the all-wheel drive (4WD) control unit.

3. Loosen the mounting screws and remove the all-wheel drive (4WD) control unit.

3. Loosen the mounting screws and remove the all-wheel drive (4WD) control unit.

4. Installation is carried out in the reverse order of removal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Valeria Kuznetsova

Send this information to your friends:

◀ Previous

Qashqai 1: Transfer case and shafts

Next ▶

All-wheel drive (4WD) control unit — device
Rear wheel hubs
Drive shafts (front and rear)
Front wheel hubs and steering knuckles
Rear final drive oil

Transfer case (4WD) — device
Transfer case assembly (4WD) — device
Removal and installation the transfer case assembly (4WD)
Transfer case components (4WD) — device
Transfer Case Components (4WD) — Post Disassembly Checks

Similar information for other Nissan models

➜ Checking the ABS control unit and drive components Nissan Serena 2 (1999-2005)
➜ Checking the voltage at the engine control unit connector Nissan Almera 1 (1995-2000)
➜ Removal and installation the heater and air conditioner… Nissan Maxima 4 (1994-1999)
➜ Removal and installation the air conditioning and audio… Nissan Murano 1 (2002-2007, petrol)
➜ Replacing grease in front wheel hubs and checking bearings… Nissan Terrano 1 (1986-1995, petrol)
➜ Panel and control drive for heating and air conditioning Nissan Patrol 4 (1987-1997, petrol)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet