1. Drive shaft.
2. Cotter pin.
Note.: replace the part with a new one after each removal.
1. Drive shaft.
2. Cotter pin.
Rear Drive Shafts (4WD) — Device (Nissan Qashqai J10)
1. Drive shaft.
2. Cotter pin.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Valeria Kuznetsova
Similar information for other Nissan models
➜ Front drive shafts — device Nissan Serena 2 (1999-2005)
➜ 4WD Models — On-Car Repair. Rear Drive Shafts Nissan X-Trail 2 (2007-2013, petrol)
➜ Rear suspension device Nissan Almera 1 (1995-2000)
➜ General information about clutches and drive shafts Nissan Maxima 4 (1994-1999)
➜ Drive shafts — repair Nissan Murano 1 (2002-2007, petrol)
➜ Replacing grease in front wheel hubs and checking bearings… Nissan Terrano 1 (1986-1995, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Faults en route
- Daily checks
- User manual
- Maintenance
- Power unit
- Petrol engines 1.6L (HR16)
- Petrol engines 2.0L (MR20)
- Diesel engines 1.5L (K9K)
- Diesel engines 2.0L (M9R)
- Cooling system
- Engine lubrication system
- Engine power system
- Engine management system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Car gearbox
- Transfer case and shafts
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Safety system
- Heating and air conditioning
- Electrical equipment
- Wiring harnesses
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.