Table of contents: Check after removal ↓ Post-installation check ↓
Check after removal
Check the wheel hub with bearing assembly for wear, cracks and damage. Replace if necessary.
Post-installation check
Check the wheel alignment angles.
Rear Wheel Hubs (4WD) — Checks (Nissan Qashqai J10)
Check the wheel hub with bearing assembly for wear, cracks and damage. Replace if necessary.
Check the wheel alignment angles.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Valeria Kuznetsova
Similar information for other Nissan models
➜ Replacing grease in front wheel hubs and checking bearings… Nissan Terrano 1 (1986-1995, petrol)
➜ Rear wheel hub device Nissan Almera 1 (1995-2000)
➜ Removal and installation the rear hub assembly with wheel… Nissan Maxima 4 (1994-1999)
➜ Checking the rotational resistance of the rear wheel hub… Nissan Murano 1 (2002-2007, petrol)
➜ Servicing front wheel hubs and drive shafts Nissan Patrol 4 (1987-1997, petrol)
➜ Rear hubs and hub bearings Nissan Primera 1 (1990-1996, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Faults en route
- Daily checks
- User manual
- Maintenance
- Power unit
- Petrol engines 1.6L (HR16)
- Petrol engines 2.0L (MR20)
- Diesel engines 1.5L (K9K)
- Diesel engines 2.0L (M9R)
- Cooling system
- Engine lubrication system
- Engine power system
- Engine management system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Car gearbox
- Transfer case and shafts
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Safety system
- Heating and air conditioning
- Electrical equipment
- Wiring harnesses
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.