2. Tune in to the desired station using one of the methods below. The tuning frequency value will appear on the display.
Setting in software mode
3. Press the station selection button that has been memorized in advance. The receiver will automatically tune in to that station, and the display will show the button number (see subsection 1.4.3).
Continuous search mode
4. This mode searches for a station. When a station is received, tuning stops automatically. Press both sides of the TUNE button at the same time and wait for a continuous beep. The receiver will automatically search for the nearest higher or lower frequency station. After a confident reception, the tuning stops. The next time you press the button, the search will continue until the next station is reliably received.
5. If, due to a too weak signal, it is not possible to tune in after a single scan of the entire frequency range, the search will continue, but with increased sensitivity, and the DX symbol will appear on the display.
Manual setting
6. Press both sides of the TUNE button simultaneously for up to 0.5 s. Each time the button is pressed, it jumps to a frequency where broadcasting is possible.