Sensor location
Angle sensor (variable resistance) mounted on the right side of the damper body.
Removal and installation
1. Disconnect the battery from ground.
2. Disconnect the connector.
3. Mark the orientation of the sensor relative to the housing.
4. Unscrew the two screws and remove the sensor.
5. When assembling, make sure that the sensor lever engages with the throttle lever.
6. Align the marks and tighten the screws slightly.
7. Adjust the sensor so that its resistance is within the normal range.
8. Tighten the sensor screws and connect the connector.
The article was obtained from the portal: NissanBook.ru
9. Connect the battery to ground.