Table of contents: Drive shaft seal ↓ Gear Selector Rod Seal ↓
Drive shaft seal
1. Drain the oil from the gearbox housing.
2. Remove the drive shaft (see chapter "Front suspension").
3. Remove the old seal.
4. Install the new seal, having first applied universal grease to its working edges.
5. Install the drive shaft.
NOTE: On F30A and F31A models, the right and left oil seals are installed the same way using ST33400001.
Gear Selector Rod Seal
1. Disconnect the gearbox control rod from the rod fork.
2. Knock out the stem fork mounting pin. Be careful not to damage the protective boot.
[Text duplicated from the website nissanbook.ru]
3. Remove the old piston rod seal.
4. Install the new seal using a mandrel, having first applied universal grease to its working edges.