1. The check is performed on a cold box. Remove the shield and wipe the crankcase near the inspection hole plug (photo).
2. Unscrew the plug and clean. The oil level should reach the bottom edge of the hole. If the oil starts to flow out when you unscrew the plug, the level is normal.
3. If necessary, add oil using a bulb or syringe.
4. Screw in the plug and tighten to the specified torque. Install the shield.
(Material borrowed from the website: «nissanbook.ru»)
Checking the oil level in the transfer case (Nissan Terrano 1)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Andrey Lazarev
Similar information for other Nissan models
➜ Checking the transfer case before disassembly Nissan Murano 1 (2002-2007, petrol)
➜ Checking the engine oil level Nissan Almera 1 (1995-2000)
➜ Checking the power steering fluid level Nissan Maxima 4 (1994-1999)
➜ Transfer case — general information Nissan Patrol 4 (1987-1997, petrol)
➜ Checking the power steering fluid level Nissan Primera 1 (1990-1996, petrol)
➜ Checking the coolant level Nissan Qashqai 1 (2006-2013)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engines 4-cylinder
- Engines 6-cylinder
- Engine overhaul
- Cooling and ventilation
- Fuel and exhaust systems
- Engine electrical equipment
- Decreased toxicity
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- All-wheel drive system
- Chassis
- Brake system
- Car suspension
- Steering
- Body and electrical equipment
- Body elements
- Doors, locks and windows
- Equipment and devices
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.