Removal
1. Disconnect the master cylinder push rod from the pedal.
2. Unscrew the pedal limiter or clutch release sensor from the bracket.
3. Unscrew the nut and remove the pedal axle (photo).
4. Remove the pedal and spring.
5. Wash the parts in solvent and replace those that are heavily worn or damaged. The bushing is pressed into the pedal, so if the bushing is heavily worn, the entire pedal is replaced.
Installation
6. Installation is carried out in reverse order.
2.6 When installing the pedal, lubricate the indicated areas
1. Lubricate
Caution! Lubricate the pedal axle, thrust pad, servo spring and master cylinder pusher pin with grease (photo)
Original text on the website: Nissanbook.ru
Adjustment
7. After installation, check the height and free play of the pedal. If necessary, adjust by performing the operations described in Chapter 1.