1. A centering rod is usually required to center the driven disk (KV30101000), shown in the illustration. If such a rod is not available, the existing clutch shaft can be used. If both options are not possible, the driven disk can be aligned using a rod whose outer diameter matches the inner diameter of the splined joint. Screw a journal onto this rod, which has the same inner diameter as the pilot bearing in the crankshaft. Craftsmen can align the disk by eye. When installing the driven disk, install the longer side of the disk hub outward, i.e. toward the gearbox.
Using a special centering rod when installing the clutch.
2. Before installing the clutch, coat the shaft splines with a small amount of grease.
3. If the previous clutch is being installed, install the clutch basket according to the marks on the flywheel.
4. Tighten the clutch bolts in a crisscross pattern in several passes in the sequence shown in illustrations, with a force of 22 - 29 Nm. In this case, frequently remove and insert the centering rod to check the installation.