2. Remove the engine protection tray.
3. Remove the air filter housing with the intake duct.
4. Remove the windshield wipers and hood top cover.
5. Remove the EGR module (EGR) assembled.
6. Remove the turbocharger assembly.
7. Loosen the exhaust manifold mounting nuts from the edges to the middle and remove the exhaust manifold from the engine.
Attention. Be careful not to deform the turbocharger pipes when removing the exhaust manifold.
8. Clean the contact surfaces of the exhaust manifold and cylinder head.
9. Installation is made in an order, the return to removal. Use a new gasket.
Note. Tighten the exhaust manifold mounting bolts in the sequence shown in the figure to 26.0 Nm.
Check after installation
Start the engine and run it at a higher RPM to check for exhaust gas breakthroughs.