Changing from low beam to high beam and back
Low and high beam
Right and left turn signals
To turn on the light, turn the button at the end of the lever.
First position: Only the parking light, rear light, number plate light and instrument panel light are switched on.
Second position: headlights are also turned on.
To turn on the high beam, push the lever forward. To turn on the low beam, move the lever in the opposite direction. To turn on the indicator light, move the lever further back.
The indicator lamp in the instrument cluster indicates that the high beam is on. The light signal can be turned on even if the headlight switch is not turned on.
To turn on the flashing indicator, move the switch lever up or down.
After passing a curved section, the flashing indicator light automatically switches to its neutral position. However, when changing lanes, you must manually return the signal switch to its original position. You can signal a lane change as follows: move the flashing indicator switch only slightly in the desired direction and then hold it with your hand.
If the green light in the instrument cluster flashes faster than usual, this indicates that the bulb in the front or rear flashing signal has burned out. If the indicator light does not flash at all, the fuse or the indicator light itself has probably burned out.