Table of contents: Removal ↓ Installation ↓
The lever is located at the top of the transmission.
Removal
1. Locate the clutch cable and loosen the cable housing locknut and knurled adjusting nut.
2. Unhook the cable and remove the cable housing from the bracket.
3. Inside the cabin, disconnect the cable from the pedal, which may require removing the dash panel.
4. Pull the cable through the engine compartment bulkhead, you can also unscrew the two bolts securing the shell holder and remove the holder together with the cable.
5. Bend the staples and remove the cable.
6. Check the cable for signs of wear or damage.
7. Check the freedom of movement of the cable in the sheath. Keep in mind that when installing in place, the cable may jam, despite the apparent ease of movement in a fully straightened state.
Installation
1. Lubricate the cable ends and pass them through the bulkhead.
2. Secure the shell holder.
3. Place the cable on the pedal.
4. Lay the cable and secure it with staples.
5. Place the cable on the fork lever and adjust the clutch pedal.