WARNINGS:
- Before working on the security system, turn off the ignition, disconnect both wires from the battery and wait at least 10 minutes.
- Work on the side or bottom of the airbag.
- Special bolts are coated with a fixing compound. After unscrewing, replace them with new ones.
- Position the airbag module with the trim panel facing up.
1. Open the glove box lid.
2. Disconnect the airbag module connector.
3. Remove the glove box (see chapter «Body»).
4. Loosen the nuts and special bolts using a T50 T50 socket with center hole.
Remove the airbag module from the instrument panel.
The airbag module is quite heavy and needs to be supported with two hands.
Installation is carried out in the reverse order. Make sure that the wiring harness is not pinched by the airbag module.